2004-2011 Ford Lincoln Navigator 5.4L SOHC V8 24v “5” (16)Intake & (8)Exhaust Valves
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| MPN | WIN5382, V4376 V4377, ZWIN-4215 |
| Year | 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Make | |
| Model | Navigator |
| Trim | 5-door SUV |
| Engine | 5.4 L InTech DOHC V8, 5.4 L Triton SOHC V8, 2007–2014 version: Triton SOHC 5.4L V8, 2015 refresh: EcoBoost 3.5L V6 |
| Intake Valve | .2356"-Stem, 1.331"-Head, 4.618"-Long, Chrome Stem |
| Exhaust Valve | .2346"-Stem, 1.476"-Head, 4.583"-Long, Chrome Stem, EV-16 Hi-Grade Stainless |
| Valve Quantity | Exhaust Valve – 16, Intake Valve – 8 |
| Warranty | 3 Year |
| Part Number | WIN5382, V4376 V4377, ZWIN-4215, V-4686, V-4708, V-4685, 02118, 02119 |
| Condition | New |
Fit In Five Steps
How to replace a Ford Lincoln Intake-Exhaust Valves?
1.Tools Required For Repair
- Valve Spring Install/Remover Tool
- Small Magnet
- Adequate light
2.Locate Valves
Select your valve spring compressor tool of choice and compress down the spring until the retainer is almost even to the top of the valve stem. Use a magnet to pull the retainer clips out from around the valve stem. There should be two of them.
3.Remove Valve Springs, Retains, Valve And Retainer Clips
Once both of the retaining clips are removed relax the pressure on the valve spring and remove the spring and retainer from on top of the head. Reach under the head and slide the valve out the bottom being careful not to damage the valve seal or the valve guide.
4.Cleaning Up Valves
Thoroughly clean all the carbon off of the valve before you install. Not that you have to do this, but you have the valves out and there is a performance to be gained here depending on how bad your valves are. The easiest way to clean the valves is with a wire brush wheel. Below are some before and after pictures of cleaning up the exhaust valves and the wire brush wheel I used.
5.Install Valve Springs, Retains, Valve And Retainer Clips
Slide the valve up through the valve guide and through the valve seal. Place the valve spring around the valve guide. Then place the retainer on top of the spring. Compress the spring with your compressing tool till you can clearly see the tip of the valve stem. Seat both retaining clips with the tapered end facing down around the valve stem and slowly release the spring. As you release the spring, make sure that the retaining clips seat correctly around the valve stem and seat well against the retainer.
$104.80
Got something to discuss?