1992-2004 Lexus ES300 Toyota Avalon Camry Power Steering Gear Rack & Pinion Assembly
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| MPN | 1ASTG00003, AM-199272398, RF Num 763, 44250-33160 |
| Year | 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 |
| Make | |
| Model | Avalon, Camry, Es300 |
| Trim | Sedan 4-door, Coupe 2-door, Wagon 4-door |
| Engine | 3.0l 2959cc V6 Gas DOHC Naturally Aspirated, 2.2l 2164cc L4 Gas DOHC Naturally Aspirated |
| Placement on Vehicle | Front-Left, Right |
| Fitment Type | Direct Replacement |
| Kit or Single Part | Single Part |
| Warranty | Lifetime |
| Part Number | 1ASTG00003, AM-199272398, REFERENCE NUMBER 763, HOLLANDER 551-58576; 77; 78; 58775. 776, OE # 44250-33160 |
| Condition | New |
Fit In Five Steps
How to replace a Lexus ES300 Power Steering Gear Rack & Pinion Assembly?
1.Secure the Vehicle
Set the front tires forward using the steering wheel and lock the steering in place to keep the tires in alignment. Then remove both the positive and negative cables from the car battery. Use a jack and jack stands to elevate the car and remove the front wheels.
2.Locate the Steering Rack & Pinion
Locate the power steering rack and pinion assembly and prepare for the removal process. Drain the power steering fluid and detach the steering column lower joint.
3.Remove the Old Steering Rack & Pinion
Remove all nuts from the inner and outer tie rods, and disconnect the tie rod ends from the steering knuckles. Detach the front exhaust tube and place a support below the engine. Remove the center member and all nuts attached to the engine mounts. Remove all nuts from the bulkhead hole cover and move the cover aside. Take the lower joint off the rack and pinion. Remember the steering neutral position by making a mark on the pinion housing and shaft. Detach the power steering fluid pipes and mounting bracket bolts, and then remove the rack and pinion altogether.
4.Replace the New Steering Rack & Pinion
Guide the new rack and pinion into position and replace the mounting brackets. Tighten the nuts to 54-72 foot-pounds of torque. Connect the power steering fluid pipes to the rack and pinion. The lower pressure line should be torqued to 20-29 foot-pounds and the higher pressure line should be torqued to 11-18 foot-pounds. Align the lower steering joint and pinion shaft, and torque to 17-22 foot-pounds. Replace the bulkhead hole cover and tighten to 36-43 inch-pounds. Replace the front stabilizer. Place the engine mounting center member back into position, tightening all bolts to 57-72 foot-pounds. Then take the support out from below the engine. Tighten the nuts on the tie rod ends to 22-29 foot-pounds and secure a new cotter pin in place.
5.Rearrange all Removal Parts and Take Test Drive
Install all other objects in the opposite order of their removal. Fill the power steering reservoir with fluid, and then bleed the system. Perform a four-wheel alignment if needed. Have the front end aligned to reset the toe-in adjustment to specification or the vehicle will handle poorly and wear out the tire quickly.
$195.29
Got something to discuss?