1989-2000 Cadillac Chevrolet GMC Oldsmobile ACDelco Fuel Pump and Engine Oil Pressure Indicator Switch
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| MPN | 19244518, D1843 |
| Year | 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000 |
| Make | |
| Model | Astro, Blazer, Bravada, C1500, C1500 Suburban, C2500, C2500 Suburban, C3500, C3500HD, Escalade, Express 1500, Express 2500, Express 3500, G10, G1500, G20, G2500, G30, G3500, Jimmy, K1500, K1500 Suburban, K2500, K2500 Suburban, K3500, P30, P3500, R1500 Suburban, R2500, R2500 Suburban, R3500, s10, S10 Blazer, Safari, Savana 1500, Savana 2500, Savana 3500, sonoma, Syclone, Tahoe, Typhoon, V1500 Suburban, V2500 Suburban, V3500, Yukon |
| Trim | All |
| Engine | All |
| Fitment Type | Direct Replacement |
| Warranty | Yes |
| Part Number | 19244500, 19244518, 1S6635, 1S6647, 53-33585, 53-33595, 57037, 57308, D1843, PS220, PS234 |
| Condition | New |
Fit In Five Steps
How to replace a Cadillac Fuel Pump and Engine Oil Pressure Indicator Switch?
1.Locate the Switch
The placement of the oil pressure switch will vary with car make. As a general rule, however, you’ll find the switch close to the oil filter or just under it. If you’re not certain, the best thing to do is consult the service manual for your vehicle.
2.Drain the Oil
Since it can be difficult to obtain good access to the oil pressure switch when the oil filter is on, changing the oil pressure switch as part of a service is suggested. To do this, place a large basin under the oil pan and open the drain plug with a wrench. Then, using an oil filter wrench, loosen the oil filter before removing it by hand. You’ll now be able to get to the oil pressure switch.
3.Remove the Switch
You’ll see that a connect cable goes to the oil pressure switch that you need to unplug. There will be a rubber boot covering and protecting the switch to keep dirt away. You’ll need to carefully peel it back from the switch and then push down on a tab. Doing this will let you unlock the connector to the oil pressure switch, and then you’ll be able to remove the boot.
4.Replace with a New Switch
If any oil spills when you remove the oil pressure switch, wipe it up with a rag before you screw the new switch in with your hand. Tighten it all the way down with your socket wrench. Then, snap the connector on to the new switch and roll down the boot so the oil pressure switch is fully protected. Clip the cable back onto the switch.
5.Add New Filter and Oil
Dip your finger in the old oil in your basin and run over the rubber gasket on the new filter before you screw it onto the engine. Use the oil filter wrench to secure it firmly. Then, close the drain plug on the oil pan and refill the engine with the correct amount of new oil; your service manual will tell you how much to put in. Finish by putting the oil cap back on. Check your work before you clean up by switching on the engine and checking that the oil pressure switch is working correctly. It should not come on at all if the work carried out isn’t satisfactory. Finally, dispose of the old oil and filter responsibly.
$14.80
Got something to discuss?