89412-34010 | 1994-2004 Toyota 4Runner Pickup T100 Tacoma Lexus LS400 SC300 SC400 New EGR Valve Temperature Sensor
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
89412-34010, 5S2029, SU5370
1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001
4Runner, LS400, Pickup, SC300, Sc400, T100, Tacoma
Base Coupe 2-Door, Base Crew Cab Pickup 4-Door, Base Extended Cab Pickup 2-Door, Base Sedan 4-Door, Base Sport Utility 4-Door, Base Standard Cab Pickup 2-Door, DLX Extended Cab Pickup 2-Door, DLX Standard Cab Pickup 2-Door, Limited Sport Utility 4-Door, Pre Runner Crew Cab Pickup 4-Door, Pre Runner Extended Cab Pickup 2-Door, Pre Runner Standard Cab Pickup 2-Door, SR5 Extended Cab Pickup 2-Door, SR5 Sport Utility 4-Door
2.4L 2366CC l4 GAS SOHC Naturally Aspirated, 2.4L 2438CC l4 GAS DOHC Naturally Aspirated, 2.7L 2694CC l4 GAS DOHC Naturally Aspirated, 3.0L 2997CC l6 GAS DOHC Naturally Aspirated, 3.4L 3378CC V6 GAS DOHC Naturally Aspirated, 4.0L 3967CC V8 GAS DOHC Naturally Aspirated, 4.0L 3969CC V8 GAS DOHC Naturally Aspirated
|Placement on Vehicle||
|Country/Region of Manufacture||
89412-34010, AIXTEX:5S2029, WELLS MSG – SU5370, ETS51, 5S2029, 779-351, FE6586, EGR386, 89412 34010, 70-3545, 2502-307040
Fit In Five Steps
How to replace a Toyota 4Runner Exhausts Gas Recirculation?
1.Materials Needed for Repair
- Free repair manuals
- Protective gloves
- Repair manuals (optional) Chilton
- Safety glasses
2.Locate the EGR Temperature Sensor
The EGR temperature sensor is usually mounted in the exhaust manifold or mounted near the EGR valve. Disconnect the negative battery cable and set it aside.
3.Remove the EGR Temperature Sensor
Remove the electrical connector by pushing down on the tab and sliding it off. Unscrew the sensor using a ratchet or wrench. Remove the old EGR temperature sensor.
4.Install the New EGR Temperature Sensor
Mount the new EGR temperature sensor in position. Screw in the new sensor by hand and then tighten it down using a ratchet or wrench.
5.Reconnect Removal Parts & Check
Connect the electrical connector by sliding it into place. Reconnect the negative battery cable and tighten it down. Take a test drive to check for sensor level.