Specification

Brand

Year

2002

Make

,

Model

Sable, Taurus

Trim

Sedan 4-Door, Wagon 4-door

Engine

3.0L 2986CC 182Cu. In. V6 FLEX OHV Naturally Aspirated

Placement on Vehicle

Front

Fitment Type

Direct Replacement

Warranty

Yes

Part Number

2F1A-12A650-SC, 590-06441A

Condition

Used

Fit In Five Steps

How to replace a Ford Taurus & Mercury Sable Engine Computer Control Module?

1.Secure Yourself

Open the engine compartment to access the battery. Disconnect the battery with a socket wrench.

2.Locate ECM

Locate the ECM either in the engine compartment or under one of the front seats in the vehicle. The ECM is a silver, rectangular module. Consult your owner’s manual or appropriate car dealership for the location of the ECM if you don’t know.

3.Remove Old ECM

Disconnect the electrical supply by lifting the locking tab and pulling away from the computer. This will isolate the electrical power. Unbolt the screws holding the ECM in place with a socket wrench. Pull the old ECM out.

4.Replace New ECM

Replace it with the new one. Bolt the ECM in place with the socket wrench. Ensure the bolts are tight. Plug in the electrical wires to the ECM. The wiring harness will lock in once it is pushed in far enough.

5.Replace all Removed Parts and Check Engine

Connect the battery cables to the battery. Tighten the cables with a socket wrench. Start the vehicle and allow it to idle for five minutes. If there are still conflicting codes, the “Check Engine” light will come on.

Got something to discuss?


 
2F1A-12A650-SC | 2002 Ford Taurus & Mercury Sable Engine Computer Control Module
2F1A-12A650-SC | 2002 Ford Taurus & Mercury Sable Engine Computer Control Module