1997-2016 GM Models OPT7 FluxBeam LED Headlight Kit 9005 9006 H1 H3 H4 H7 H11 H13 6000K 6K Bulbs Low
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| Year | 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 |
| Make | Acura, Audi, BMW, Buick, Chevrolet, Dodge, Ford, GMC, Honda, Hyundai, Infiniti, Jeep, Kia, Lexus, Mazda, Mercedes-Benz, Mini, Nissan, Ram, Scion, Subaru, Toyota, Volkswagen |
| Model | All |
| Trim | All |
| Engine | All |
| Placement on Vehicle | Front |
| Fitment Type | Direct Replacement |
| Kit Includes | 2 Bulbs, 2 drivers, 1 manual |
| Color | 6000K Cool White |
| LED | CREE MK-R |
| Lumens per bulb | 3,538lm |
| Wattage per Bulb | 30w |
| Voltage | 8-32v |
| Fan Speed | Dual 7,000 RPM TurboCool fan |
| Warranty | 2 Year |
| Part Number | Fluxbeam-led-headlight-parent-56750 |
| Condition | New |
Fit In Five Steps
How to replace a GM Headlight Bulbs?
1.Tools you Need Repair
- New light bulb(s) — Make sure you get the right type of bulb for your vehicle (your local auto parts store should be able to match a bulb with your make and model)
- Alcohol wipes and tissues (to clean and hold the new bulb)
- Phillips screwdriver
2.Locate the Headlight Holder
You’ll access your headlight bulb through your engine compartment, rather than from the front of the car. Open your hood and locate the headlight near the front of the vehicle. It will be in a bulb holder, with a power connector (usually three wires) leading to the bulb.
3.Remove the Power Wires
The power wires are attached to a plug at the base of the headlight, and held by a plastic catch, a metal clip or a screw cap, depending on your vehicle. The plastic catch will have a small lever at the top — push down on it while you pull the plug out. If you’re dealing with a metal clip, pull it up and away, and be sure to hold onto it as you pull. If you’re dealing with a screw cap, you can unscrew it by turning it counter-clockwise.
4.Remove the Old Bulb
Once the wires have been disconnected, you should be able to remove the back of the headlight holder and remove the old bulb by holding onto the base. In some cases, you may have to rotate the bulb a bit to get it free.
5.Clean and Install the New Bulb
Handle the new bulb with tissues or gloves — you don’t want oils from your skin getting on it. You should also give it a good cleaning with an alcohol wipe before you install it. Once the bulb is ready, stick it into the base of the plug. If it’s installed correctly, none of the bulb’s rubber gasket will be showing. Once the bulb is in you can put the headlight holder back in place and plug the power wires back in. Make sure you test the bulb by turning on your headlights.
$29.99
Got something to discuss?