1967 Chevrolet Camaro Pontiac Firebird GTO Windshield Wiper Motor Kit
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| Year | 1967 |
| Make | |
| Model | Camaro, Firebird, GTO |
| Trim | Base, Base Hardtop 2-door, Rs Convertible 2-door, Ss Convertible 2-door, Ss Hardtop 2-door, Z28 Hardtop 2-door |
| Engine | 6.6l 6555cc 400cu. In. V8 Gas Ohv Naturally Aspirated, 6.6l 400cu. In. V8 Gas Naturally Aspirated, 6.5l 6489cc 396cu. In. V8 Gas Ohv Naturally Aspirated, 5.7l 5736cc 350cu. In. V8 Gas Ohv Naturally Aspirated, 5.3l 5358cc 327cu. In. V8 Gas Ohv Naturally Aspirated, 4.9l 4949cc 302cu. In. V8 Gas Ohv Naturally Aspirated, 4.6l 4638cc 283cu. In. V8 Gas Ohv Naturally Aspirated, 4.1l 4098cc 250cu. In. L6 Gas Ohv Naturally Aspirated, 3.8l 3769cc 230cu. In. L6 Gas Ohv Naturally Aspirated |
| Placement On Vehicle | Front |
| Fitment Type | Direct Replacement |
| Single Part Or Kit | Kit |
| Warranty | 3 Year |
| Part Number | NE6700CF |
| Condition | New |
Fit In Five Steps
How to replace a Chevrolet Windshield Wiper Motor?
1.Materials Needed for Repair
- Allen set metric and standard sockets
- Assorted pliers
- Assorted screwdrivers
- Brass hammer
- Clip Remover
- Combination wrench set, metric and standard
- Disposable gloves
- Emery cloth/sandpaper
- Flashlight
- Metric and standard wrench set
- Pry bar
- Ratchet ⅜ drive
- Seal Remover
- Socket set metric and standard ⅜ drive
- Socket set metric and standard ¼ drive
- Torque wrench ⅜
- Torx socket set
- Wiper removal tool
2.Remove the Wiper Blades
You will have to remove the wiper blades in order to gain access to the cowl, which is where the windshield wiper motor is located. Use a windshield wiper removal tool to release the tension on them so you can remove them. The cowl might have some clips holding it down. You will need to remove them using a clip remover or another suitable tool.
3.Remove the Old Windshield Wiper Motor
Now that you have gained access to the wiper motor, you can unplug it and unbolt it from the wiper gearbox assembly that connects to the wiper blades. Once you remove that, then you can remove the motor from the vehicle.
4.Install the New Windshield Wiper Motor
Remount the windshield wiper motor back onto the wiper gearbox assembly. Bolt it back onto the cowl housing and plug it back in, then reinstall the cowl plastic and the clips.
5.Reinstall the Wiper Arms
Once you have finished installing the new motor and putting the cowl back together, reinstall the wiper arms and wiper blades onto the wiper gearbox assembly. Tighten them down to the correct torque. Make sure you put them in the correct location so that when you activate them they will clean the windshield properly. If they don’t, you can always readjust them.
BUY HERE
$219.00
Got something to discuss?