2005-2007 Toyota Sequoia All-Weather Carpet Floor Mats
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
2005, 2006, 2007
Limited Sport Utility 4-door, SR5 Sport Utility 4-Door
4.7l 4663cc 285cu. In. V8 Gas Dohc Naturally Aspirated
|Placement on Vehicle||
Taupe Rubber with Logo
|OE Spec or Performance/Custom||
Fit In Five Steps
How to replace a Toyota Sequoia Carpet Floor Mats?
Leave the rubber flooring kit out in the sun while you disassembling the carpet from your vehicle. The heat from the sun will make the rubber flooring more pliable and easier to work with. Open all the doors on your vehicle before removing the carpet.
2.Prepare For Removing Floor Carpets
Remove the kick panels by hand by pulling up on the plastic nuts in the corners and removing the clips that secure the carpet along the door jam. Free the rocker sill plates by pulling up to release the clips.
3.Remove Old Floor Carpets
Take out the car seats by using a 3/8-inch ratchet to remove the bolts in the seat tracks. Remove the tracks and the seats themselves. Lift the seats out of the car by placing one hand on the bottom of the seat and the other on the headrest. You can leave the back seat inside the car. Pull the old car carpet loose by starting in one front corner. Roll the carpet away from the dash and towards the rear of the car. Remove the entire section of carpet out of the car.
4.Place New Floor Carpet
Arrange the rubber flooring outside the car so the forward section is aligned with the front of the car. Fold the back portion of the rubber flooring towards the middle and the front portion of the back, creating a burrito-like shape. Lift the rubber flooring into the car and place it in the middle of the cab. Be sure the front is still facing the front of the vehicle.
5.Clean and Tighten The Screws
Roll the front section of the rubber flooring towards the dash. Make sure the seat belts and the flooring line up and everything lay flat in place. Unroll the back section of the rubber flooring in the back of the car. Press the rubber into place and along the grooves of the cab. Put the car seats back into the vehicle.
Got something to discuss?