1986-1992 Toyota Supra MK3 7MGTE Upgrade CT26 T61 Turbo Charger with Oil Kit

Fit In Five Steps

How to replace a Toyota Supra MK3 7MGTE Upgrade CT26 T61 Turbo Charger with Oil Kit?

1.Oil Pipes and Engine Oil

Before you install the replacement turbocharger, the first job is to change the oil and associated filtration systems. Remove and replace the oil feed pipe from the turbocharger and ensure that the new pipe is free from kinks and blockages. Then replace the oil filter and replace the engine oil. It is important to have new, clean oil as impurities in older oil could play havoc with your new turbocharger’s bearings. Finally, remove all the crankcase hoses and filters, and either clean or replace them in line with the recommendations in your owner’s manual.

2. Clear Out your Engine

Immobilise the engine and then turn the engine over until around about half a pint of oil is pumped out of the turbo oil feed pipe. This is a vital step that ensures all particulates are removed from your system, preventing your new turbocharger from becoming contaminated. You are now ready to start with the replacement work, but remember the turbocharger is a sensitive part so cleanliness is vital throughout the change procedure.

3. Remove the Old Turbocharger

The first step is to remove the bolts that connect the exhaust downpipe from the turbocharger and unscrew the air intake, which is typically held in place by a Phillips head screw. This now leaves you free to loosen the main bolts that hold the turbocharger and the exhaust manifold in place. Typically you will need to undo these with a ratchet. Finally, take the turbocharger off the car.

4. Install the New Turbocharger

As with all replacement parts check the new turbocharger against the old part. You are looking to make sure that all the fixings are in the same place to check you have the exact part required. It’s then a simple case of reversing the previous steps. First connect the main bolts to the exhaust manifold, before screwing the air intake into place, and finally reconnecting the exhaust downpipe.

5. Connection & Final Checks

The next step is to connect the oil pipe to the turbocharger. Before fitting this ensure that the blanking plug is removed if necessary, and turn over the engine until oil flows out of the turbocharger bearing housing. Refit the pipe and tighten all connections, taking care not to over-tighten.

When you have installed the new turbocharger, it is vital that you check there are no oil leaks from the part. Simply start the car and make sure there are no leaks from any part of the turbocharger, and no visible exhaust fumes coming from the exhaust manifold or downpipe. If you have a boost gauge you can use this to check that the boost pressure is within the manufacturer’s specified limits.