2002-2013 Nissan Sentra X-Trail and Altima 2.5L Ignition Coils Pack Set of 4
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| MPN | UF-350 610-58632, UF350 IC122 ICA225 |
| Year | 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013 |
| Make | |
| Model | Altima, Sentra, X-Trail |
| Trim | Sedan 4-Door, Sport Utility 4-Door |
| Engine | 2.5L 2488CC 152Cu. In. l4 GAS DOHC Naturally Aspirated, 2.5L 2500CC l4 GAS DOHC Naturally Aspirated |
| Placement on Vehicle | Front |
| Fitment Type | Direct Replacement |
| Surface Finish | Textured |
| Voltage | 12 Volts |
| Warranty | Lifetime |
| Part Number | 224338H315; 224488H300, 22448-8H310, 22448-8H311, 22448-8H315, 52-1746, 5C1395, AA-3356-4, C1398, E380, IC480, UF-350, UF-350 610-58632, UF350, UF350 IC122 ICA225 |
| Condition | New |
Fit In Five Steps
How to replace a Nissan Sentra X-Trail and Altima 2.5L Ignition Coil?
1.Materials Needed for Repair
- Replacement ignition coil
- Screwdrivers
- Service manual specific to your vehicle
- Socket set and ratchet
- Wrenches
Disconnect the negative battery cable to cut power to the vehicle. Use a socket or wrench to disconnect the clamp bolt holding the cable to the terminal.
2.Locate the Ignition Coils
Locate the ignition coils on top of the engine. They will be attached to the engine block or surrounding components.
3.Disconnect And Remove The Old Ignition Coil
You will need to disconnect the bolts or screws attaching the coil to the vehicle. You will also need to disconnect the electrical connectors from the coil. Determine which connection needs to be broken first depending on your particular make and model. On some vehicles, the electrical connections need to be unscrewed or unplugged first, while on others, you will need to unbolt the unit before you can disconnect the electrical connectors. You can refer to your vehicle’s service manual to determine the proper procedure for your particular car.
4.Install the New Ignition Coil
Install the new ignition coil in reverse of the order in which you disconnected the old one. If you previously disconnected the electrical connectors first, reconnect them last after securing the mounting bolts or screws.
5.Reconnect the Battery & Test the New Coil
Reattach the negative battery terminal to the car battery to restore power to the vehicle. Hand tighten the electrical connection and then use a socket or wrench to tighten down the terminal bolt. Start the engine with the vehicle in park to test the new ignition coil. If the vehicle starts and idles normally, you can then test drive the vehicle.
$37.95
Got something to discuss?