1996-1997 Dodge Ram 2500 3500 Truck Cummins 5.9L Diesel Manual Engine Computer Module

0

Specification

Brand

Year

1996, 1997

Make

Model

Ram 2500, Ram 3500

Trim

Base Cab & Chassis 2-Door, Base Extended Cab Pickup 2-Door, Base Standard Cab Pickup 2-Door

Engine

5.9L 359Cu. In. l6 DIESEL OHV Turbocharged

Placement on Vehicle

Front

Fitment Type

Direct Replacement

Warranty

Yes

Surface Finish

Resurfaced

Condition

Refurbished

Fit In Five Steps

How to replace a Dodge Ram 2500 3500 Truck Cummins 5.9L Engine Computer Module?

1.Check the Engine Computer

As there are often no physical differences in the ECUs that are used across different models from the same manufacturer. It is therefore imperative to check that you have the exact part number specific to your vehicle when ordering.

2.Unplug the Battery

The first step is to unplug the battery from the car so that there is absolutely no power running through your vehicles circuits. You then need to let your car sit for around quarter of an hour disconnected from any power source. This is to let all the information clear from the memory chips in the computer, ensuring that no old instructions can corrupt the new unit.

3.Remove the Engine Computer

Use your owner’s manual to find the exact location of the ECU. In many vehicles, this will be accessible through the passenger compartment of the car, although you may need to take out pieces of carpet to access the unit. When you have found the ECU you’ll need to remove the bracket and screw that hold it in place. Normally these will be Phillips head screws, so make sure you have the right kind of screwdriver. The final step is unplugging the wiring harness, which again will often be secured via a single bolt.

4.Install the New Engine Computer

When you have removed the old ECU there may be a diagnostics mode that allows you to track down the exact fault in the part, and you might even be able to perform some kind of reset that clears the problem. If you cannot revive the part in this manner then install the new ECU by attaching the wiring harness and then screwing back into its housing.

5.Reconnection

It is now time to reconnect the battery and turn on the auxiliary switch on the engine. This is where the lights come on, but the engine does not fully engage. Let the car sit for five minutes, giving the computer and ECU time to configure correctly. Finally turn off the car and start it as you would normally. The car should start right away.

Got something to discuss?


 
1996-1997 Dodge Ram 2500 3500 Truck Cummins 5.9L Diesel Manual Engine Computer Module
1996-1997 Dodge Ram 2500 3500 Truck Cummins 5.9L Diesel Manual Engine Computer Module

$759.99