1986-1995 Jeep AMC Renault Manifold Absolute Pressure MAP Sensor

Fit In Five Steps

How to replace a Jeep AMC Renault Manifold Absolute Pressure MAP Sensor?

BUY HERE

1.Materials Needed & Locate MAP Sensor

• Gloves
• Pliers
• Replacement MAP sensor
• Socket wrench

Being familiar with the part you are looking for should help you locate the bad sensor on your vehicle. If you do not know where it is or what it looks like, study the replacement part to help you identify it in the engine bay. To help narrow down your search, keep in mind that there will be a rubber vacuum hose running to the MAP sensor, as well as an electrical connector with a group of wires coming from the connector.

2.Use Pliers to Remove the Retaining Clamps

Any clamps retaining the vacuum line should be disconnected and moved down the length of hose to free the vacuum line from the nipple it is connected to on the MAP sensor.

3.Remove Old Honda Acura Manifold Absolute Pressure MAP Sensor

Remove any bolts holding the MAP sensor to the vehicle.Use the socket wrench to remove any bolts securing the sensor to the vehicle. Set them aside in a safe place.  Unplug the electrical connector by squeezing the tab down while firmly pulling the connectors apart. At this point, the sensor should be free to be removed. Remove it and connect the new sensor to the electrical connector.

4.Install New Honda Acura Manifold Absolute Pressure MAP Sensor

If the MAP sensor was bolted to the vehicle, replace these bolts. Make sure to tighten the bolts, but do not overtighten them. Small bolts will break easily if over-tightened, especially on older vehicles. An easy method to get consistent results is to use a wrench with a short handle.

5.Reinstall Removal Parts

Replace the vacuum line and any clamps that were removed. Once the vacuum hose is reconnected, the replacement is complete.
BUY HERE