2006-2015 Chevrolet Impala Rear Driver Side Power Window Regulator with Motor

0

Price list

Still could not find the Part? Contact us @ Find Exact Part in 24 Hours

Specification

Brand

, , , , ,

MPN

1AWRG01797, 20927599, 748-510, AM-54493163, WR848512

Year

2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016

Make

Model

Impala, Impala Limited

Trim

Sedan 4-Door

Engine

3.5 L Lz4 V6 (Gasoline), 3.5 L Lze V6(gasoline/e 85)[43], 3.6 L Lfx V6 (Gasoline/e85), 3.9 L Lz8 V6 (Gasoline), 3.9 L Lz9 V6 (Gasoline)[44], 3.9 L Lzd V6 (Gasoline/e85), 3.9 L Lzg V6 (Gasoline/e85)[44], 5.3 L Ls4 V8 (Gasoline)[45]

Placement on Vehicle

Rear-Left

Fitment Type

Direct Replacement

Material

Metal

Surface Finish

Silver

Warranty

Lifetime

Part Number

1AWRG01797, AM-54493163, DOR 748-510, OE # 19180071, OE # 2092759, WR848512

Condition

New

Fit In Five Steps

How to replace a Chevrolet Impala Rear Power Window Regulator with Motor?

BUY HERE

1.Removing the Door Panel

  • Pry off the trim piece inside the door handle with a flat blade screwdriver
  • Pry up the window switch panel with a flat blade screwdriver
  • Disconnect the window switch wiring harnesses
  • Pull off the side panel next to the window
  • Remove the 6mm bolt next to the window
  • Remove the two 8mm bolts inside the door handle
  • Remove the 10mm bolt inside the door pull
  • Remove the two 6mm bolts at the bottom of the door panel
  • Pry out the door panel
  • Lift the door panel up and off
  • Disconnect the latch cables from the door handle
  • Remove the 5.5mm or 7/32 bolts from around the speaker
  • Pull off the speaker
  • Disconnect the speaker wiring lead
  • Carefully peel off the water shield

2.Removing the Window Regulator

  • Loosen the two 10mm bolts that hold the window to the regulator
  • Pry your fingers between the cushions holding the window
  • Raise the window by hand
  • Hold the window in place with painter’s tape
  • Disconnect the window motor lead
  • Remove the four 10mm bolts from the regulator
  • Remove the 10mm bolt from the window motor
  • Unclip the wire on the door
  • Pull the window regulator out through the door

 3.Installing the New Window Regulator

  • Push the regulator into the door
  • Hang the regulator by its bolts
  • Tighten the four 10mm bolts into the regulator
  • Tighten the 10mm bolt into the regulator motor
  • Push the clip into the door
  • Connect the window motor to the lead

4.Testing the Regulator

  • Connect the window switch to the switch panel
  • Turn the vehicle on
  • Run the motor up for 4 seconds
  • Disconnect the switch panel

5.Reinstalling the Door Panel

  • Put the water shield into place
  • Insert the 5.5mm or 7/32 bolts around the speaker
  • Connect the speaker wiring lead
  • Put the speaker in place
  • Connect the latch cables to the door handle
  • Lift the door panel into place
  • Push in the door panel clips
  • Insert the two 6mm bolts at the bottom of the door panel
  • Insert the two 8mm bolts inside the door handle
  • Insert the 10mm bolt inside the door pull
  • Insert the 6mm bolt next to the window
  • Connect the window switch wiring harness
  • Push in the switch panel
  • Push on the trim piece inside the door handle
  • Push on the trim panel next to the window

BUY HERE

Got something to discuss?


 
2006-2015 Chevrolet Impala Rear Driver Side Power Window Regulator with Motor
2006-2015 Chevrolet Impala Rear Driver Side Power Window Regulator with Motor