Specification

Brand

, ,

MPN

1AWRG01052, 741-428, AM-40218442

Year

2004, 2005, 2006, 2007, 2008

Make

Model

F-150

Trim

Crew Cab, Regular Cab

Engine

4.2L 256Cu. In. V6 GAS OHV Naturally Aspirated, 4.6L 281Cu. In. V8 GAS SOHC Naturally Aspirated, 5.4L 330Cu. In. V8 GAS SOHC Naturally Aspirated

Placement on Vehicle

Front-Left

Fitment Type

Direct Replacement

Warranty

Lifetime

Part Number

125-02136L, 1AWRG01052, 4L3Z1523201CA, 660270, 6L3Z1523201BA, 741-428, AM-40218442

Condition

New

Fit In Five Steps

BUY HERE

How to replace a Ford F150 Power Window Regulator?

1.Removing the Door Panel

  • Pry off the trim piece inside the door handle with a flat blade screwdriver
  • Pry up the window switch panel with a flat blade screwdriver
  • Disconnect the window switch wiring harnesses
  • Pull off the side panel next to the window
  • Remove the 6mm bolt next to the window
  • Remove the two 8mm bolts inside the door handle
  • Remove the 10mm bolt inside the door pull
  • Remove the two 6mm bolts at the bottom of the door panel
  • Pry out the door panel
  • Lift the door panel up and off
  • Disconnect the latch cables from the door handle
  • Remove the 5.5mm or 7/32 bolts from around the speaker
  • Pull off the speaker
  • Disconnect the speaker wiring lead
  • Carefully peel off the water shield

2.Removing the Window Regulator

  • Loosen the two 10mm bolts that hold the window to the regulator
  • Pry your fingers between the cushions holding the window
  • Raise the window by hand
  • Hold the window in place with painter’s tape
  • Disconnect the window motor lead
  • Remove the four 10mm bolts from the regulator
  • Remove the 10mm bolt from the window motor
  • Unclip the wire on the door
  • Pull the window regulator out through the door

 3.Installing the New Window Regulator

  • Push the regulator into the door
  • Hang the regulator by its bolts
  • Tighten the four 10mm bolts into the regulator
  • Tighten the 10mm bolt into the regulator motor
  • Push the clip into the door
  • Connect the window motor to the lead

4.Testing the Regulator

  • Connect the window switch to the switch panel
  • Turn the vehicle on
  • Run the motor up for 4 seconds
  • Disconnect the switch panel

5.Reinstalling the Door Panel

  • Put the water shield into place
  • Insert the 5.5mm or 7/32 bolts around the speaker
  • Connect the speaker wiring lead
  • Put the speaker in place
  • Connect the latch cables to the door handle
  • Lift the door panel into place
  • Push in the door panel clips
  • Insert the two 6mm bolts at the bottom of the door panel
  • Insert the two 8mm bolts inside the door handle
  • Insert the 10mm bolt inside the door pull
  • Insert the 6mm bolt next to the window
  • Connect the window switch wiring harness
  • Push in the switch panel
  • Push on the trim piece inside the door handle
  • Push on the trim panel next to the window

BUY HERE

Got something to discuss?


 
2004-2008 Ford F-150 Front Power Window Regulator With Motor Driver Side Left
2004-2008 Ford F-150 Front Power Window Regulator With Motor Driver Side Left