2003-2011 Saab 9-3 Front Power Window Regulator Driver Side Left LH
Price list
$82.95
$221.78
March 18, 2020 5:14 am
×
Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon.com (Amazon.in, Amazon.co.uk, Amazon.de, etc) at the time of purchase will apply to the purchase of this product.
20 new
from $ 82.95
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| MPN | 752-914 |
| Year | 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Make | |
| Model | 9-3 |
| Trim | Sedan 4-Door, Wagon 4-door |
| Engine | 2.0L 1998CC 122Cu. In. l4 GAS DOHC Turbocharged, 2.8L 2792CC 170Cu. In. V6 GAS DOHC Turbocharged |
| Placement on Vehicle | Front-Left |
| Fitment Type | Direct Replacement |
| Warranty | Lifetime |
| Part Number | 12 793 728, 125-59004BL, 12793728, 1AWRG02594, 752-914, AM-4021371750 |
| Condition | New |
Fit In Five Steps
How to replace a Saab 9-3 Power Window Regulator?
1.Removing the Door Panel
- Pry off the trim piece inside the door handle with a flat blade screwdriver
- Pry up the window switch panel with a flat blade screwdriver
- Disconnect the window switch wiring harnesses
- Pull off the side panel next to the window
- Remove the 6mm bolt next to the window
- Remove the two 8mm bolts inside the door handle
- Remove the 10mm bolt inside the door pull
- Remove the two 6mm bolts at the bottom of the door panel
- Pry out the door panel
- Lift the door panel up and off
- Disconnect the latch cables from the door handle
- Remove the 5.5mm or 7/32 bolts from around the speaker
- Pull off the speaker
- Disconnect the speaker wiring lead
- Carefully peel off the water shield
2.Removing the Window Regulator
- Loosen the two 10mm bolts that hold the window to the regulator
- Pry your fingers between the cushions holding the window
- Raise the window by hand
- Hold the window in place with painter’s tape
- Disconnect the window motor lead
- Remove the four 10mm bolts from the regulator
- Remove the 10mm bolt from the window motor
- Unclip the wire on the door
- Pull the window regulator out through the door
3.Installing the New Window Regulator
- Push the regulator into the door
- Hang the regulator by its bolts
- Tighten the four 10mm bolts into the regulator
- Tighten the 10mm bolt into the regulator motor
- Push the clip into the door
- Connect the window motor to the lead
4.Testing the Regulator
- Connect the window switch to the switch panel
- Turn the vehicle on
- Run the motor up for 4 seconds
- Disconnect the switch panel
5.Reinstalling the Door Panel
- Put the water shield into place
- Insert the 5.5mm or 7/32 bolts around the speaker
- Connect the speaker wiring lead
- Put the speaker in place
- Connect the latch cables to the door handle
- Lift the door panel into place
- Push in the door panel clips
- Insert the two 6mm bolts at the bottom of the door panel
- Insert the two 8mm bolts inside the door handle
- Insert the 10mm bolt inside the door pull
- Insert the 6mm bolt next to the window
- Connect the window switch wiring harness
- Push in the switch panel
- Push on the trim piece inside the door handle
- Push on the trim panel next to the window
2003-2011 Saab 9-3 Front Power Window Regulator Driver Side Left LH
$221.78 $82.95
Got something to discuss?