2002-2006 Ford Mercury Windshield Wiper Turn Signal High Low Beam Lever Switch
Price list
Still could not find the Part? Contact us @ Find Exact Part in 24 Hours
Specification
| Brand | |
|---|---|
| MPN | 112732, 1AZCC00176, 3983-0645, AM-48769491 |
| Year | 2002, 2003, 2004, 2005, 2006 |
| Make | |
| Model | Expedition, Explorer, Mountaineer |
| Trim | Sport Utility 4-Door |
| Engine | 4.0L 245Cu. In. V6 FLEX SOHC Naturally Aspirated, 4.6L 281Cu. In. V8 GAS SOHC Naturally Aspirated, 5.4L 330Cu. In. V8 GAS SOHC Naturally Aspirated |
| Placement on Vehicle | Front-Left |
| Fitment Type | Direct Replacement |
| Warranty | Lifetime |
| Part Number | 13K359, 1L2T13K359AGJAEA, 1L2TAGJAEA, 2L2Z, 2L2Z13K359AAB, 629-00670, 629-00706, AAB, CBS-1172, SW5676, SW6072 |
| Condition | New |
Fit In Five Steps
How to replace a Ford Mercury Windshield Wiper Lever Switch?
1.Materials Needed for Repair
- Allen set metric and standard sockets
- Assorted pliers
- Assorted screwdrivers
- Brass hammer
- Clip Remover
- Combination wrench set, metric and standard
- Disposable gloves
- Emery cloth/sandpaper
- Flashlight
- Metric and standard wrench set
- Pry bar
- Ratchet ⅜ drive
- Seal Remover
- Socket set metric and standard ⅜ drive
- Socket set metric and standard ¼ drive
- Torque wrench ⅜
- Torx socket set
- Wiper removal tool
2.Remove the Wiper Blades
You will have to remove the wiper blades in order to gain access to the cowl, which is where the windshield wiper motor is located. Use a windshield wiper removal tool to release the tension on them so you can remove them. The cowl might have some clips holding it down. You will need to remove them using a clip remover or another suitable tool.
3.Remove the Old Windshield Wiper Motor
Now that you have gained access to the wiper motor, you can unplug it and unbolt it from the wiper gearbox assembly that connects to the wiper blades. Once you remove that, then you can remove the motor from the vehicle.
4.Install the New Windshield Wiper Motor
Remount the windshield wiper motor back onto the wiper gearbox assembly. Bolt it back onto the cowl housing and plug it back in, then reinstall the cowl plastic and the clips.
5.Reinstall the Wiper Arms
Once you have finished installing the new motor and putting the cowl back together, reinstall the wiper arms and wiper blades onto the wiper gearbox assembly. Tighten them down to the correct torque. Make sure you put them in the correct location so that when you activate them they will clean the windshield properly. If they don’t, you can always readjust them.
BUY HERE
$29.66
Got something to discuss?