2008-2014 Cadillac Chevrolet Saturn Buick Pontiac Suzuki PowerAid Throttle Body Spacer

Fit In Five Steps

How to replace a Throttle Body Kit Spacer?

1.Locate Your Throttle Body

Open your hood and locate your engine’s throttle body. Remove the air intake duct at the throttle body. Inspect the throttle body ports for carbon build up. Throttle bore wear is also common for long periods of time and throttle body assemblies will need to be replaced if worn. Remove the throttle cable from the throttle body control lever.

2.Tools Required

• Screwdrivers
• Socket set
• Spanners
• Needle pointed pliers

3.Removing Throttle Body Kit Spacer

Disconnect any air or vacuum hoses from the throttle body. Remove the throttle position sensor from the throttle body. Remove the throttle body mounting screws and remove the throttle body assembly. Discard the old gasket and install a new gasket between the throttle body and manifold during installation.

4.Install New Throttle Body Kit Spacer

Match the new throttle body to the old throttle body making sure that sensors, hoses, and cables are all routed correctly to the new throttle body and that it mounts correctly to the intake manifold. Install in reverse procedure and follow manufacturer torque specifications during installation.

5.Start the engine

Start your engine and pay attention to the idle of the engine to verify the repair.