AM105574 | Denso Lawn Mover Ignitor Assembly

Fit In Five Steps

BUY HERE

How to replace a John Deere Ignition Ignitor?

1.Materials Needed

• Boxed end wrench or ratchet sets
• Flashlight or drop light
• Flat blade and Phillips head screwdrivers
• Replacement ignition ignitor
• Safety equipment (safety glasses)

2.Locate the Distributor and Remove the Distributor Cap

Locate the vehicle’s battery and disconnect the positive and negative battery cables before proceeding. The ignition ignitor is located inside the distributor. If you don’t remove battery power, the potential of being shocked is extremely high.

After you’ve removed any components that are obstructing your access to the distributor, remove the distributor cap. Most of the time, the distributor cap will be held on by two or three clips or two or three Phillips head screws.

3.Remove the Ignition Ignitor

Most ignition ignitors are connected to the distributor through a series of male to female connections as well as a ground wire attached to a Phillips head screw. Remove the screw that holds the ground wire and carefully pull on the ignition module until it slides off of the distributor.

4.Install the Ignition Ignitor

First, attach the ground wire to the screw that held the original ignition ignitor ground. Next, slide the ignition ignitor male connectors into the female connection slots. Make sure the ignition ignitor is solidly mounted before you begin to reassemble the distributor.

5.Test Drive the Vehicle

It’s recommended to test drive your vehicle to ensure the repair was completed right. If you turn the key and the engine starts, the repair was completed successfully.
BUY HERE